Use this 14" anchor spike to securely fasten rubber speed bumps, speed humps, and parking stops in asphalt or gravel surfaces. To install, lay out the item and mark the pre-set holes on the ground surface, drill a hole into the asphalt, and hammer the anchor spike through the parking stop until it is snug against the surface. If the asphalt is older, it may help to coat the spikes with epoxy during install to prevent the asphalt from cracking.
Note:These 14 inch landscape spikes are not for use with concrete surfaces.
Note: Each product below requires multiple spikes; see the respective product detail page for quantities needed.
Item Number | Description |
---|---|
STN-6Y | 6’ Rubber Car Parking Stop |
PAH-SP | Premium Textured Rubber Speed Hump |
PAB-SP | 6' Premium Textured Rubber Speed Bump |
SB72N | 6' Standard Rubber Speed Bump |
SB72-2H | 6’ Low Profile Rubber Speed Bump |
SBECN | Speed Bump End Cap For SB72N Speed Bumps |
Single set of one 14” x 1/2” rebar spike and washer.