14” Asphalt Rebar Spike for Speed Bumps and Parking Stops

14” Asphalt Rebar Spike for Speed Bumps, Speed Humps, and Parking Stops

Use this 14" anchor spike to securely fasten rubber speed bumps, speed humps, and parking stops in asphalt or gravel surfaces. To install, lay out the item and mark the pre-set holes on the ground surface, drill a hole into the asphalt, and hammer the anchor spike through the parking stop until it is snug against the surface. If the asphalt is older, it may help to coat the spikes with epoxy during install to prevent the asphalt from cracking.

These 14 inch landscape spikes are not for use with concrete surfaces.

For use with the following item numbers:

Note: Each product below requires multiple spikes; see the respective product detail page for quantities needed.

Includes:

Single set of one 14” x 1/2” rebar spike and washer.

Resources:

For Concrete Installation:

More Speed Bumps and Humps